The United Tool and Die Company
AS9100:D and ISO 9001:2015
One Carney Road • West Hartford, CT 06110 • (860) 246-6531
Established 1923 •Fax: (860) 246-6723
Capabilities & Equipment

Inspection Equipment

Below, you are viewing the Inspection Equipment section of UTD's Facilities List.

  • 1 Fabrivision
    Laser Scanner for Flat Patterns, Flat Pattern Inspection, Computerized print out, Note – Reduced Inspection time. From 48 minutes to 12 minutes on one part. 
  • 1 Sheffield CMM
    Coordinate measuring machine (CMM), accurate measurements without fixtures. 
  • 1 Romer CMM
  • 1 Aicon TubeInspect
    'TubeInspect' eliminates the need for numerous bending gauges and drastically reduces change-over time. 'TubeInspect' has been designed for the fast, automated inspection of tubing. Using this system, no fixtures or holding devices are required and data is provided in seconds. A 3D measuring system that measures XYZ, end to end points and bend data for tubing. 'TubeInspect' is designed for the fast automated inspections of tubes and ducts which eliminates the need for fixtures and holding devices 
  • 1 Metra Scan

« Back to capabilities

© 2022 The United Tool and Die Company. An Aerospace tube, duct and sheet metal fabricator in West Hartford, Connecticut 06110 (CT)